Every PW25 Is Built to Order
Custom builds require a deposit to begin production. Alternatively, fully rigged turnkey boats are offered with financing as they become available.
Built by Hand. Proven by Water.
Every PW25 is hand-crafted in our Oak Hill, Florida facility using premium materials and time-tested techniques.
Base Packages
- Hull with self-bailing floor
- Rub rail protection
- 70 gallon fuel tank
- Enclosed transom*
- 2 storage hatches
- Anchor locker
- 6 Gemlux cleats
- 24" x 24" x 48" C&M marine console
* Enclosed transom requires an extended jack plate or bracket for motor mounting. Motors can only be direct-mounted to an open transom.
- Hull with self-bailing floor
- Rub rail protection
- 50 gallon fuel tank
- 25" open transom
- 1 storage hatch
- Anchor locker
- 6 Gemlux cleats
- 24" x 24" x 48" C&M marine console
Power Options
Installation included
Recommended: 115 HP, up to 175 HP
Recommended: 70 HP or 90 HP per engine
Complete electrical system — all wires ran, standard electrical panel rigged, installation included
Blue Sea Electrical Parts
- 8-switch weather deck panel
- Battery switch with ACR
- Common busbar
- 7184 circuit breaker
- 5026 ST Blade Fuse Block
- Maxibus bar 250 AMP
- Fuse block terminals
- MRBF fuses
- Waterproof inline fuse holders
- 4.8 Amp USB port
Single engine: 2 batteries • Twin engine: 3 batteries
Batteries & Hardware
- Two batteries (single) / Three batteries (twin)
- Battery trays
- PVC board
- Epoxy mounting glue
- Heat shrink
- Zip tie holders
- #8 screws
- Lugs & butt connectors
- Ring terminals
Bilge & Lights
- Two Rule 1500 GPH bilge pumps
- Two Rule float switches
- 1 1/8" SS thru-hull & hose
- SS hose clamps & hardware
- Caulk
- Bow lights
- Stern lights
- Courtesy lights
Build your boat with these options — pricing includes installation
Premium aluminum dual axle trailer by Rock and Roll
Includes 3 rod holders and a 40 gallon live well
Includes 4 rod holders, grab rails, and flip-up foot rest
Plumbing and installation for the leaning post live well
Reference PW25 photos
Bennett 6x12" trim tabs with switch, wiring & installation
Note: Plus 6.5% sales tax (unless out of state with proper paperwork). Electronics, additional rod holders, and cup holders not included in base pricing.